This laptop was released in April of , it is an upgrade of the series. Dell Inspiron troubleshooting, repair, and service manuals. Removing Dell Inspiron LCD from Display Assembly: This guide shows how to disassemble the Step 3 Optical Drive (Based on Dell Service Manual). service manual before you begin system components memory cd or dvd drive modem and mini pci card. 9f33c0 dell inspiron service manual get user.
|Published (Last):||15 October 2012|
|PDF File Size:||18.64 Mb|
|ePub File Size:||14.83 Mb|
|Price:||Free* [*Free Regsitration Required]|
Ensure that the speaker cables are under or between their routing clips.
A microprocessor module that is not properly seated can result in an intermittent connection or permanent damage to the microprocessor and ZIF socket.
To avoid damaging the computer, perform the following steps before you begin working inside the computer. Back to Contents Page For a complete list of abbreviations and acronyms, see the Tell Me How help file. Comments to this Manuals Your Name. Hard drives are extremely fragile; even a slight bump can damage the drive.
Lift the Mini PCI card out of its connector. Ensure that the work surface is flat and clean to prevent the computer cover from being scratched. Slide the new drive into the bay until the drive is fully seated.
Information sergice this document is subject to change without notice. The placemat provides the number of screws and their sizes. Enter text from picture: Page 8 Back to Contents Page Page 15 Back to Contents Page Installing the System Board 1.
Got it, continue to print. A NOTE indicates important information that helps you make better use of your computer. Carefully separate the bezel from the top cover to avoid damage to the bezel.
To continue using , please upgrade your browser.
Dell does not guarantee compatibility or provide support for hard drives from sources other than Dell. Removing The Memory Modules To prevent static damage to components inside your computer, discharge static electricity from your body before you touch any of your computer’s electronic components. Also See for Inspiron Owner’s manual – pages Service manual – 63 pages Setup manual – 2 pages.
Disconnect the touch pad connector from the system board. Connect the fan power cable to the system board. Ensure that the AC adapter is plugged in, the main battery is properly installed, and a network cable is attached.
You can do so by touching an unpainted metal surface. Lift the display assembly up and out of the computer base. Don’t show me this message again. Use firm and even pressure to slide the drive into place.
Starting at the bottom of the display panel, use your fingers to separate the bezel from the top cover and lift the inside edge of the bezel away from the top cover.
Turn off your computer. Removing The Modem 1.
Dell Inspiron 1150 Service Manual
Replace the memory module cover and tighten the captive screw. Trademarks used in this text: Route the display-feed flex cable so that it rests in the notch located in the bottom edge of the top cover. To prevent static damage to components inside your computer, discharge static electricity from your body before you touch any of your computer’s electronic components. Connect the bottom flex-cable connector to the inverter connector.
Starting at the back center of the palm rest, use your fingers to separate the palm rest from the base plastics by lifting the inside edge of the palm rest. Remove the two M2. If you use excessive force, you may damage the connector.