DAC/DAC 8-Bit µP Compatible, Double-Buffered D to A Converters. General Description. The DAC is an advanced CMOS/Si-Cr 8-bit multiplying . As the name itself points out ‘DAC’ is a DAC chip or Digital to Analog Conversion IC. The device is from DAC series that are 8-bit. DAC/DAC 8-Bit μP Compatible, Double-Buffered D to A Converter Data LM Operational Amplifier Data Sheet, National Semiconductor Corp.
|Published (Last):||28 June 2017|
|PDF File Size:||4.91 Mb|
|ePub File Size:||8.10 Mb|
|Price:||Free* [*Free Regsitration Required]|
This also permits the simultaneous updating of any number of DACs.
DAC Technical Data
DAC takes in parallel 8 bit data from a microcontroller or microprocessor and converts that data in to analog signal at the output. The device is specifically designed for it to be interfaced directly with the,Z80, and other popular microprocessors.
We can use the circuit to develop applications without worry as the datsaheet is tested working. TL — Programmable Reference Voltage. This op-amp circuit is called current-to-voltage converter.
This analog signal is the current quantity that is directly proportional to the input digital value and this current parameter needed to be converted in to datashet parameter for further use. The chip is designed with CMOS technology to achieve low power consumption and low output leakage current errors.
For working of device DAC we have connected a voltage source of 15V as shown in diagram. The design also includes special circuitry that provides TTL logic input voltage level compatibility. So to convert the current parameter in to voltage parameter we will use op-amp circuit as shown in satasheet diagram.
The device is available in the market for low cost and sac0832 be easily worked with. So the device is used for converting 8 bit parallel digital data input to analog signal output.
DAC Datasheet(PDF) – National Semiconductor (TI)
Submitted by admin on 21 November DAC IC basically used in applications where an 8 bit digital data needed to be converted to analog value. All these control pins need to be setup appropriately as mentioned above for successful DAC conversion of the device. Double buffering of the device allows outputting a voltage corresponding to one datasheft word while holding the next digital word.
The analog voltage output from the op-amp circuit is in direct relation with inputted digital value and hence DAC conversion with DAC is achieved. Now for understanding the working let us consider the example application circuit given in the datasheet.
DAC also designed with silicon-chromium R-2R resistor ladder network which divides the reference current and provides the circuit with excellent temperature tracking characteristics 0. Pin Configuration DAC is a twenty pin device and description datsaheet each pin is given datasheeet.